Package Release Info

limesuite-19.01.0-bp151.2.2

Update Info: Base Release
Available in Package Hub : 15 SP1

platforms

AArch64
ppc64le
s390x
x86-64

subpackages

libLimeSuite19_01-1
limesuite
limesuite-devel
limesuite-udev
soapysdr0.7-module-lms7

Change Logs

* Thu Mar 07 2019 Martin Hauke <mardnh@gmx.de>
- Upate to version 19.01.0
  LimeSuite library changes:
  * Allow filtering devices by partial serial number
  * Add GPIO control for LimeSDR-Mini
  * Change LMS_VCTCXOWrite() to save value to non-volatile storage
  * Change LMS_VCTCXORead() to read value from non-volatile storage
  * Make some improvements in GFIR setup
  * Fix Tx not working when Rx is disabled on LimeSDR-Mini
  * Add initial support for LimeNET-Micro
  * Add auto RF path selection option (LMS_PATH_AUTO) for
    LMS_SetAntenna()
  * Remove LMS_Disconnect() and LMS_IsOpen() functions from API
  * Add support for sending smaller Tx packets (improve end of
    burst handling)
  * Change Rx RF path set by LMS_Init() for LimeSDR-USB to LNA_L
  * Disable Tx channel in LMS_Init()
  LimeSuiteGUI:
  * Add GPIO controls to "Board controls" panel for LimeSDR-Mini
  * Add option to "Board controls" panel to write VCTCXO value to
    non-volatile storage
  SoapyLMS:
  * Update to soapysdr0.7 module ABI
  * add manual DC/IQ calibrations
  Other changes:
  * LimeUtil: fix LimeSDR-Mini not exiting programming mode after
    flashing FPGA
  * LimeQuickTest: test 1st board when multiple boards are detected
    (instead of exiting)
  * Add Octave plugin to CMake build
  * Add log handler to Octave plugin
  * Add IQ/DC calibration to basicTX example
  * LimeSDR-USB v1.4 updated to r2.20 gateware
  * LimeSDR-Mini updated to r1.29 gateware
* Sat Nov 10 2018 mardnh@gmx.de
- Update soapy-module version 0.6 -> 0.7
* Fri Oct 05 2018 mardnh@gmx.de
- Upate to version 18.10.0
  LimeSuite library changes:
  * Fix CalibrateTxGain() XBUF settings for 3rd party boards
  * Add interpolation/decimation support for SISODDR mode
  * Always use SISODDR mode for LimeSDR-Mini
  * Fix Rx filter calibration for 2nd channel with low bandwidth
    values
  * Fix index lookup for opt_gain_tbb cache (ChB out of bounds)
  * Add SXT/SXR VCO cache
  * Add FPGA register cache
  * Add connection remote (disabled by default)
  * Fix incorrect TBB gain control behaviour under certain
    conditions
  * Disable GFIR coefficient ordering based on oversampling when
    coefficient count is to high
  * Remove late timestamp reset commands from Rx streaming loop
  LimeSuiteGUI:
  * Update board controls panel
  * Add LPF coefficient calculation controls for GFIRs to TxTSP
    and RxTSP tabs
  Other changes:
  * LimeSDR-USB v1.4 updated to r2.18 gateware
  * LimeSDR-Mini updated to r1.27 gateware
  * Add Tx only LMS API example
  * SoapyLMS: remove stream activity checks
* Wed Jun 13 2018 mardnh@gmx.de
- Update to version 18.06.0
  LimeSuite library changes:
  * Fixed zero filled packet transmitted on Tx FIFO timeout
  * Fixed LMS_GetFrequency() to return correct frequency in TDD mode
  * Added HBD/HBI bypass mode for LimeSDR-USB
  * Made automatic Tx gain calibrations less frequent
  * Fixed some issues with GFIR usage
  * Some fixes for LimeSDR-QPCIe
  SoapyLMS changes:
  * Fixed writeSetting to not throw every time
  * Added 'skipCal' stream argument to disable calibration
  * Added 'CALIBRATE' setting for writeSetting()
  Other changes:
  * Added LimeSDR-USB support to LimeQuickTest
  * Added sample format and Tx sync selection to FFTviewer
  * Fix LimeSuiteConfig for debian packages
  * LimeSDR-USB v1.4 updated to r2.17 gateware
  * LimeSDR-Mini v1.1 updated to r1.25 gateware
Version: 18.04.1-bp150.1.3
* Thu Apr 19 2018 mardnh@gmx.de
- Update to version 18.04.1
  * Add multiple device support for LimeSDR-Mini
  * Add QuickTest Utility for LimeSDR-Mini
  * Remove calibration cache database
  * LimeSuiteGUI: Remove duplicate information from 'Device Info' panel
- Remove patch:
  * limesuite-fix-cmake-path.patch (fixed upstream)
* Mon Apr 09 2018 mpluskal@suse.com
- Cleanup with spec-cleaner
* Fri Apr 06 2018 mardnh@gmx.de
- Update to version 18.04.0
  * Fixed Tx filter calibration
  * Fixed FPGA PLL configuration when B channel is disabled
  * Fixed non-working controls in LimeSuiteGUI 'TRX Gain' tab
  * Changed CGEN VCO tune algorithm
  * LimeSDR-USB v1.4 updated to r2.16 gateware
- Add patch:
  * limesuite-fix-cmake-path.patch
- Update to version 18.03.0
  SoapyLMS changes:
  * Do not tune NCO when LO is within tuning range
  * Filter BW reported to match filtersCalibration
  * Function implementations changed to use same code as LMS API
  LimeSuiteGUI changes:
  * Added log levels
  * Added additional controls to SPI panel
  * Reduced number of programming modes in Programming panel
  LimeSuite library changes:
  * Added LimeSDR-Mini programming
  * Changed default settings for LimeSDR-Mini
  * Updated calibrations
  * Add phase alignment for dual channel configuration
  * Updated FPGA PLL configuration
  * Fix B channel only streaming
  * Fixed LMS7002M::GetPathRFE for LNAH case
  * Fixed CGEN not tuning to 484-487 MHz
  LMS API changes:
  * LMS_Open() can no longer succeed without connecting to hardware
  * LMS_Disconnect() and LMS_IsOpen() are now deprecated because of above change
  * Changed firmware/gateware programming functions
  * Changed lms_dev_info_t structure
  * LMS_SetLOFrequency() now attempts to set different frequencies for A/B channels using NCO
  * Fix Rx NCO direction flip (downconvert flag used to set Rx NCO to upconvert)
  * Disabling LPF is now same as setting it to maximum bandwidth
  * Extented gain range for LMS_SetGaindB()
  Other changes:
  * Reduce SIMD flags when packaging for x86
  * LimeSDR-USB v1.4 updated to r2.15 gateware
  * LimeSDR-Mini v1.1 updated to r1.24 gateware
- Add limesuite-fix-cmake-path.patch
* Tue Dec 19 2017 mardnh@gmx.de
- Update to version 17.12.0
  SoapyLMS changes:
  * Force MIMO alignment
  * Add TBB frontend gain configuration
  * Fix/adjust gain ranges
  LMS API changes:
  * Increased USB timeouts
  * Updated FTDI library (LimeSDR-Mini on Windows)
  * RF switch control for LimeSDR-Mini
  * Updated setup/destruction of streams
  * various bug fixes
  LimeSuiteGUI changes:
  * Update LimeSDR-Mini panel
* Sun Nov 05 2017 jengelh@inai.de
- Update descriptions.
* Sat Oct 21 2017 mardnh@gmx.de
- Use SSE-SIMD-FLAGS only on x86_64 machines
* Thu Oct 19 2017 mardnh@gmx.de
- Update to version 17.10.0
  SoapyLMS changes:
  * Initial support for LimeSDR-Mini
  * Disable calibration cache by default
  LMS API changes:
  * Initial support for LimeSDR-Mini
  LimeSuiteGUI changes:
  * Added scrollbars
  * Fix multiple crashes that occured when board is not connected
  * Bring window to front when trying to open already opened window
  * Some cosmetic GUI changes
  * Added default config button to GUI
  Other changes:
  * LimeSDR v1.4 updated to r2.11 gateware
- Build with -DENABLE_SIMD_FLAGS="SSE4.2" to avoid the new default
  optimization settings "-mmarch=native" otherwise it the binaries
  are expected to crash on machines different from the build hosts.
* Sun Oct 01 2017 mardnh@gmx.de
- Update to version 17.09.1
  SoapyLMS changes:
  - SoapyLMS7 caches stream enable and disables on close
  - Fixed late packet reporting in SoapyLMS7 stream status
  LMS API changes:
  - Added simple GPIO example utilizing functions from LimeSuite.h
  - Fixed WriteStream() end of burst flushing in fifo.h
  - Fixed abs() overload compiler issue in lms7_device.cpp
  - Removed private include in mcu_program/host_src/main.cpp
  - Fixed error checking bug causing compilation error on MacOS in
    LMS_GetGaindB() and LMS_GetNormalizedGain()
  Other changes:
  - LimeSDR v1.4 updated to r2.10 gateware
- Update to version 17.09.0
  LimeSuite library changes:
  - Added transfer size adjustment based on sample rate
  - Improved MCU calibration procedures
  - Initial support for LimeSDR-QPCIe
  - Changed format to 16 bit for data transfer when float (non-native) format
    is selected in API
  LMS API changes:
  - Added external reference clock(LMS_CLOCK_EXTREF) configuration to
    LMS_SetClockFreq()
  - Change LMS_SetGaindB() and LMS_SetNormalizedGain() to select optimal
    TBB gain for TX
  - Fixed LMS_GetStreamStatus() not returning some status values
  LimeSuiteGUI changes:
  - Unified read/write params in board controls panel
  - Fixed some GUI fields not updating correctly/reporting wrong values
  Other changes:
  - LimeSDR v1.4 updated to r2.9 gateware
  - Added LMS API doxygen generation to CMake
  - Added CMake option to enable compiler SIMD flags
* Wed Jun 21 2017 mardnh@gmx.de
- Update to version 17.06.0
  API additions:
  - LMS_GPIODirRead
  - LMS_GPIODirWrite
  - LMS_CalibrateInternalADC
  - LMS_CalibrateAnalogRSSIDC
  - LMS_CalibrateRP_BIAS
  - LMS_CalibrateTxGain
  - LMS_SetClockFreqWithSpurCancelation
  General changes:
  - SoapyLMS7 - added getMasterClockRates()
  - SoapyLMS7 - added getSampleRateRange()
  - LimeSDR v1.4 updated to r2.8 gateware
  - GPIO support in SoapyLM7 module
  - Library level logging support
  - Speed up x640,x641 spi
  - FFTviewer: add checkbox for RX->TX loopback control
  - Merged major MCU based calibrations update
* Fri May 05 2017 mardnh@gmx.de
- Update soapy-module version 0.5-2 -> 0.6
* Wed May 03 2017 mardnh@gmx.de
- Update to version 17.02.2
  - Fixed register typo in LMS7002M::SetTxDCOffset()
  - Added option defaults for stream args in SoapyLMS7
  - Fixed LMS7002M::GetPathRFE() currently selected path
* Wed Apr 19 2017 mardnh@gmx.de
- initial package, version 17.02.1